Small Ploopy Adept with BTUs V2 (1.5 inch ball)

I have previously designed a smaller case for the Ploopy Adept using a 34mm trackball. I found that the ball was a bit too small, so I redesigned the case to fit a 38.1mm ball (1.5 inch, same size as the Ploopy Nano).

I have also done several improvements on the design, so now it prints easily without the need of supports and the buttons work great.

If anyone is interested, here are the instructions https://github.com/fabriciobastian/ploopy-adept-small-btu. It is in the same repo as the 34mm one from previously.

I have previously designed a smaller case for the Ploopy Adept using a 34mm trackball. I found that the ball was a bit too small, so I redesigned the case to fit a 38.1mm ball (1.5 inch, same size as the Ploopy Nano).

I have also done several improvements on the design, so now it prints easily without the need of supports and the buttons work great.

If anyone is interested, here are the instructions https://github.com/fabriciobastian/ploopy-adept-small-btu. It is in the same repo as the 34mm one from previously.