Enki42 v0.3
Lowest keyboard with case on Choc V1.
Contrasting mods from two sets of MBK legend
Minimum thickness (total height including keycaps only 15 mm )
If remove the magnets, use a 0.8 mm printed PCB, you can make it a little lower (~1.5 mm)
- Printed on FDM using two types of flexible filaments. The first few layers are soft flex, the others are hard. The bottom layer is used instead of bumpon.
- Purple cutouts for switches, microcontroller and jack
- Green cutouts for magnets 7x2 mm
- 42 keys (Kailh Choc v1)
- Per switch RGB
- Choc spacing
- Compatible with corne via controller pins
---------------------------
